Sbc Oil Leak Between Head And Block. I have been able to silicone that. over about 1,000 miles the engine develops small amount of oil present from the seal between the cylinder head and engine block. I had an oil leak right between the edge of the rear china. the oil is running down the edge between the block and the head starting at the front of the intake and going down. i had an oil leak issue on my big block chevelle that took me a while to figure out. very unlikely in my opinion that a sbc would be able to leak only oil from a head gasket, however very likely that. i have had them leak at the corner of the intake, where it meets the head and block. there is a pressure line plug installed in a pipe tapped hole on the rear of the head deck surface, in the block, but approximately at the #7. it looks like the bottom edge of the head gasket has a film of oil and runs down the block at the last two cylinders.
very unlikely in my opinion that a sbc would be able to leak only oil from a head gasket, however very likely that. there is a pressure line plug installed in a pipe tapped hole on the rear of the head deck surface, in the block, but approximately at the #7. I have been able to silicone that. the oil is running down the edge between the block and the head starting at the front of the intake and going down. it looks like the bottom edge of the head gasket has a film of oil and runs down the block at the last two cylinders. i had an oil leak issue on my big block chevelle that took me a while to figure out. i have had them leak at the corner of the intake, where it meets the head and block. over about 1,000 miles the engine develops small amount of oil present from the seal between the cylinder head and engine block. I had an oil leak right between the edge of the rear china.
Oil leaking bad between the head & block. YouTube
Sbc Oil Leak Between Head And Block it looks like the bottom edge of the head gasket has a film of oil and runs down the block at the last two cylinders. the oil is running down the edge between the block and the head starting at the front of the intake and going down. i had an oil leak issue on my big block chevelle that took me a while to figure out. i have had them leak at the corner of the intake, where it meets the head and block. I had an oil leak right between the edge of the rear china. I have been able to silicone that. very unlikely in my opinion that a sbc would be able to leak only oil from a head gasket, however very likely that. over about 1,000 miles the engine develops small amount of oil present from the seal between the cylinder head and engine block. it looks like the bottom edge of the head gasket has a film of oil and runs down the block at the last two cylinders. there is a pressure line plug installed in a pipe tapped hole on the rear of the head deck surface, in the block, but approximately at the #7.